Where did I put that wrench?

[+pablo+]

this may be a bit lame:


To have a wrench handy to adjust the wires on a Fat Congas cajon, place a piece of Velcro on the bottom (hook side), and wrap the wrench with the soft hoop side of the Velcro. So when needed…ta da! It’s right there. The feet are tall enough to clear the floor. As a side gripe, the screw size on the Fat Congas is some weird off size approx 3/16” ( and no it’s not metric … I had to custom grind the open end. Wish they would have made it the same size the ubiquitous drum key.

Attachment: http://mycongaplace.com/forum/eng/uploa ... rench1.jpg

[+pablo+]

Here is a pic with the small adjustable wrench.

Attachment: http://mycongaplace.com/forum/eng/uploa ... rench2.jpg

[+pablo+]

For a conga wrench, tear into an old hard drive, pull the magnets out and place ‘em under your throne. Slap a wrench there and it’s always handy. Place the magnet clocked to the seat label, so when you set down your throne, position the label between your legs so you just reach down and ta da! (I also place a drum key there cause they are always handy).

Now with that mag power being so close to..well..surely it got to be a good thing...

Attachment: http://mycongaplace.com/forum/eng/uploa ... rench3.jpg

[+pablo+]

pic of magnets only. Do not let kids have these cause they'll pinch the ba-geebers out of fingers. And don't place 'em on your fridge cause they'll scratch it when you try to pull them off.

Attachment: http://mycongaplace.com/forum/eng/uploa ... rench4.jpg