Recording Congas.

Manufacturers, brands, skins, maintenance, stands, sticks, michrophones and other accessories for congueros can be discussed into this forum ...... leave your experience or express your doubts!

Postby Chris D'Sylver » Tue May 17, 2005 12:44 pm

Hello.

When it comes to recording Congas.

1. Are there any special points to remember when recording ??

2. Best placement of microphones.??

3. What mic's work best for Congas. ??


Thanks.

Chris.
Is everybody ready. . .Ok,...3. 4. and 1....
User avatar
Chris D'Sylver
 
Posts: 20
Joined: Fri Apr 22, 2005 10:31 pm
Location: Mersea Island. Essex. England.

Postby Diceman » Sat May 21, 2005 12:34 pm

Chris,

Have a look on http://www.mikedolbear.com, there is an interview with the great Robin Jones, and he mentions his mike setup.

Good luck
Diceman
User avatar
Diceman
 
Posts: 495
Joined: Fri May 06, 2005 9:28 am
Location: London England

Postby Chris D'Sylver » Sat May 21, 2005 12:54 pm

Many thanks man, i'm very greatful to you.


Regards.

Chris.
Is everybody ready. . .Ok,...3. 4. and 1....
User avatar
Chris D'Sylver
 
Posts: 20
Joined: Fri Apr 22, 2005 10:31 pm
Location: Mersea Island. Essex. England.

Postby pidoca » Mon May 23, 2005 11:46 am

gday, recording congas can a be a difficult and rewarding experience. Experiment with mic placement. hve one mic for each drum close proximity, a room mic to pic up the ound of the drums in the room ( different rooms will give different sounds), one mic between two congas. When in the studio I have seen many engineers use 2 mics on two congas. they are placed about 30-45cm away from the congas, but keep in mind that they have to be closer to gether then thaey are away from the drums, so as not to get phase cancelation. Many of hte older recording were done with one room mic and it gave the music great life and "air".

in a live setting I use one mic per congas and have it about 1 inch out and 2 inch up. I have found that with the tuning that i use on my mongo santamaria's congas it works best. what mic you ue is also an important considereration, as mic have ' a proximity effect'. that is, the closer they are placed to the source the more bass. A little bass is good, to much can make it sound muddy when recorded. I used CAD mics, they are very good for the work that I am doing.

Ciao
God Bless
Pidoca
http://www.cabritamusic.com
User avatar
pidoca
 
Posts: 146
Joined: Wed Jul 30, 2003 12:18 pm
Location: CENTRAL COAST, SYDNEY, AUSTRALIA

Postby Chris D'Sylver » Mon May 23, 2005 2:54 pm

Thanks for you reply Pidoca. I'm greatful to you. Very helpful.


Cheers.

Chris.
Is everybody ready. . .Ok,...3. 4. and 1....
User avatar
Chris D'Sylver
 
Posts: 20
Joined: Fri Apr 22, 2005 10:31 pm
Location: Mersea Island. Essex. England.


Return to CongaSet and accessories

Who is online

Users browsing this forum: No registered users and 41 guests